Lowcube And Cube Slanted!!!
Moderators: Jay2k1, DavidM, The_One
Lowcube And Cube Slanted!!!
omg thats right!!! i was editing Lowcube today and cube, and i was looking at the cube it seld because i was adding a volume after i subtatracted part of the wall... so i put in a volume to block anything going in there... but i noticed that i couldnt line up the volume flush to the wall... so i looked at the side and front views, and i notice that those, AND THE FLOOR were over 20u slanter!!!
gg davidM and mappers (might wanna check that out for next DB version =D)
gg davidM and mappers (might wanna check that out for next DB version =D)
It means that the floor and walls are not square angles. It means something is not straight up and down or side to side.
It means that something is not level.
If it were a building in real life. The building inspector would make you rebuild the structure or prove that is will not become a safety concern.
It means that something is not level.
If it were a building in real life. The building inspector would make you rebuild the structure or prove that is will not become a safety concern.
ok... i put in a volume, that was striaght up and down, when i matched it to the wall, the wall was slanted back, another words, the field in side view shows the field slanted DOWN towards the left. meaning the floor is not flat, and the walls on the left are hanging over onto the field, while the other side is slanted out...
ill make a drawing later =p
ill make a drawing later =p